T121 - SnapNType

Is the SnapNType driver compatible with Macintosh?

Yes, the SnapNType driver is fully compatible with Macintosh. Simply download the driver from our web site and perform a HotSync to install snapntype.prc to your I300 and you are ready to go! You only need your Macintosh computer to HotSync the application, subsequent operation of the SnapNType will not require the computer.

Do I need to disable the SnapNType driver before performing HotSync?

Since both the SnapNType keyboard and your I300 cradle used the same serial port, you need to disable the SnapNType driver before performing a HotSync.

Do I have to disable the SnapNType driver every time I remove the device?

No, you can leave the SnapNType driver enabled all the time. The only time you may want to disable the SnapNType driver is when you need to use the serial port for another application, such as beaming or HotSync.

While the SnapNType is connected, can I beam information to other PDAs?

No. You have to disable the SnapNType driver before performing the beam action. However, you will be able to receive beam information while the SnapNType driver is enabled.